BEHR^® MASONRY, STUCCO & BRICK PAINT - SATIN NO. 280

Preparation

• Allow new stucco and masonry to cure for 30 days before painting.
• Remove all loose, peeling paint.
• Powerwash to remove chalk.
• Remove dirt and grease with a concrete & masonry degreaser & cleaner; remove mildew stains with a mildew stain removing product.
• Scuff sand or etch metals. Follow all label instructions.
• Rinse thoroughly and allow a minimum of 24 hours to dry.
• Cracks and gaps wider than 1/16" (1.5 mm) should be routed open, dusted and patched with a quality patching compound.
• Use an acrylic caulk around windows, doors and trim.
• Scuff sand glossy surfaces.
• If chalk remains on the surface, prime with a product such as BEHR® NO. 436 Exterior Multi-Surface Primer & Sealer.
• Prime all patched areas as well as adjacent wood and metal surfaces.
• If previously sealed or coated, check manufacturer's specifications before painting.

Application

• DO NOT THIN.
• Intermix all cans of same product to ensure color uniformity.
• Stir paint before and occasionally during application.
• Use product when air and surface temperature are 50-90˚F (10-32˚C).
• Do not use if rain or heavy dew is expected within 24 hours.
• Apply using a high quality 3/4"-1" nap roller (rough surfaces) or 3/8"-1/2" nap roller (smooth surfaces), nylon/polyester brush or airless sprayer (.015"-.021" spray tip, 60 mesh filter).
• Apply a second coat, if necessary. Maintain a wet edge to avoid lap marks.

Dry Time

• Longer dry time required in cooler temperatures and higher humidity.
• After two weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.

Disposal

• Properly dispose of all soiled rags.
• For disposal of empty containers and unused product contact your household refuse collection service.