Preparation of Uncoated Pavers, Brick or Natural Stone

A great looking finish begins with the right start. Following the proper prep procedures will dramatically affect the look and longevity of your finished project.

For Best Results:

For expert guidance on prepping your uncoated pavers, brick or natural stone surfaces, refer to our how-to steps below.

For your safety, please wear protective clothing, eye goggles, and acid-resistant rubber gloves and footwear.

Suggested Tools & Supplies

Broom (Stiff Bristle)
Rags
Scrub Brush
Protective Apparel
Hose
Chemical Resistant Gloves
High Pressure Nozzle
Mop

Step 1
Make sure the surface is clean. Wipe up all excess oil and grease spills. Scrape and sweep away dirt and other loose contaminants from the surface.
Step 2
Clean and degrease the surface using a plastic watering can. This will evenly distribute the product. Work the Degreaser and Cleaner into the surface using a stiff bristled, non-metal brush or broom. Allow the product to remain on the surface for 10-20 minutes then vigorously scrub the surface. DO NOT allow the surface to dry.
Step 3
Rinse the surface thoroughly with fresh water, while scrubbing at the same time to properly remove remaining residue. Pressure wash for best results.

TIP: After application, thoroughly saturate surrounding grass and plants with fresh water.
Step 4
Remove excess water with a non-metal squeegee or mop. Prevent all rinse solution from entering the storm drains. Once the surface is clean and dry, it can be sealed.