Preparation

• Remove loose paint, wash off any dirt and grease with detergent, remove mildew stains with a mildew stain removing product.
• Scuff sand glossy surfaces.
• Countersink nailheads, repair imperfections and sand smooth.
• Remove all dust with a damp cloth, allow to dry.
• Allow new stucco, plaster and masonry to cure for 30 days before priming.

Prime

• Use a product such as BEHR^® Kitchen, Bath & Trim Stain-Blocking Primer & Sealer No.75.
• On new drywall in low-moisture rooms, use a product such as BEHR^® Drywall Plus Primer & Sealer No. 73.

Application

• Use product when the surface and air temperatures are between 50 - 90°F (10-32ºC).
• Stir paint occasionally. Intermix containers of the same product to ensure color and sheen uniformity.
• Use a high quality 3/8-1/2" nap roller cover, nylon/polyester brush or an airless sprayer (.015”-.019” spray tip, 60 mesh filter).
• Coverage is 250 to 400 sq. ft. (23-37 m²) per gallon depending on the surface texture, porosity and application method.
• Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 1/2 pint per gallon.
• Certain colors may require more than one coat for complete hide.
• Popcorn style acoustic ceilings, use acoustic ceiling roller cover or airless sprayer (.015-.017 spray tip).

Dry Time

• Dries to touch in one hour at 77°F (25ºC) and 50% humidity, recoat in 2 hours. Longer dry time required in cooler temperatures and in higher humidity.
• After 2 weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.
• Dry paint film is mildew resistant

Clean Up & Storage

• Use soap and water.
• Properly dispose of all soiled rags and protect unused product from freezing.
• For disposal of unused paint products, please contact your household refuse collection service.