Protect and beautify your concrete and masonry surfaces with this premium high gloss, wet-look sealer.
For Best Results:
Your surfaces must be properly cleaned and prepped before beginning.
For new or uncoated surfaces, refer to: Preparation of Uncoated Concrete for Sealers
For uncoated pavers, brick or natural stone, refer to: Preparation of Uncoated Pavers, Brick or Natural Stone
For coated concrete: refer to: Preparation of Coated Concrete for Sealers
High Pressure Nozzle
After the surface has been cleaned and prepped, apply a thin coat of BEHR PREMIUM® Wet-Look Sealer with either a nylon-polyester brush, 1/4"- 3/8" nap roller cover, high quality pad applicator, or a high quality pump sprayer with an adjustable tip.
TIP: The spread rate is 200-450 sq. ft. per gallon. Use when air and surface temperatures are between 50-80 degrees F. Do not apply in direct sunlight, on wet surfaces, or if rain or heavy dew is expected within 24 hrs.
If the sealer is sprayed on, back roll for a uniform thickness. For added sheen and durability, additional coats (no more than 4) may be applied.
TIP: Annual touch up may be required in areas subject to tire traffic
The sealer will dry to the touch in 1 hour. Allow the first coat to dry for 4 hrs. before deciding if a second coat is needed.
Be sure the surface is fully cured before use.
Allow 24 hours for light foot traffic.
Allow 72 hours for heavy foot traffic and furniture.
Allow 14 days before subjecting to automotive tires.
Allow 30 days before rinsing or cleaning with a mild detergent.
TIP: Clean up with soap and water.
Inside or outside; paint or stain: Let’s figure out how much you’ll need to make amazing happen.
CalculateEvery project is unique: Keep small wrinkles from becoming big problems by letting the Behr Technical Experts lend a hand.
Get Expert HelpLet Pro Referral do the leg work and match you with quality local painters.
Find a Painter