How To Apply BEHR PREMIUM^® Protector and Waterproofer

Protect your surfaces from corrosion, spalling, efflorescence and freeze-thaw damage with our premium waterproofer.

For Best Results:

Make sure your surface is cleaned and prepped before applying the waterproofer.
For new or uncoated surfaces, refer to: Preparation of Uncoated Concrete for Sealers

For uncoated pavers, brick or natural stone, refer to: Preparation of Uncoated Pavers, Brick or Natural Stone

For coated concrete: refer to: Preparation of Coated Concrete for Sealers

Suggested Tools & Supplies

Step 1
After the surface is cleaned and prepped, apply the BEHR PREMIUM^® Protector and Waterproofer until the surface is saturated. Apply the product to a dry surface with a brush, roller or garden sprayer.

TIP: The spread rate is 250 sq. ft per gallon. Use when air and surface temperatures are between 50-90 degrees F. Do not apply in direct sunlight, on wet surfaces, or if rain or heavy dew is expected within 24 hrs.
Step 2
Remove any puddles by spreading product to drier areas or by wiping off excess with a clean cloth.
Step 3
On vertical surfaces, apply the waterproofer from the bottom up and saturate thoroughly.

TIP: The Proterctor and Waterproofer will cure within 24-48 hrs.
Step 4
Once dried, rough, vertical surface may be coated with an oil or latex-based paint or primer. DO NOT paint horizontal surfaces after applying this product.

Clean up with soap and water.